Hitachi LP-AW4001 - Network Command Control

97
8.4 Command Control via the Network
<RXFDQFRQ¿JXUHDQGFRQWUROWKHSURMHFWRUYLDWKHQHWZRUNXVLQJ56&
commands.
Communication Port
The following two ports are assigned for the command control.
Command Control Settings 
48)
&RQ¿JXUHWKHIROORZLQJLWHPVIURPDZHEEURZVHUZKHQFRPPDQGFRQWUROLVXVHG
Example: If the IP address of the projector
is set to 192.168.1.10:
1) Enter “http://192.168.1.10/” into the
address bar of the web browser, and
select Projector Web Control from the
selection window.
2) Enter your user name and password,
and then click the [OK].
3) Click the [Port Settings] on the main
menu.
4) Click the [Enable] check box to open
Network Control Port1 (Port: 23) to use
7&3&OLFNWKH[Enable] check box
for the [Authentication] setting when
DXWKHQWLFDWLRQLVUHTXLUHGRWKHUZLVHFOHDU
the check box.
5) Click the [Enable] check box to open
Network Control Port2 (Port: 9715)
WRXVH7&3&OLFNWKH[Enable]
check box for the [Authentication]
VHWWLQJZKHQDXWKHQWLFDWLRQLVUHTXLUHG
otherwise clear the check box.
8. Other Functions
7&3(Network Control Port1 (Port: 23))
7&3(Network Control Port2 (Port: 9715))
&RPPDQGFRQWUROLVDYDLODEOHRQO\YLDWKHVSHFL¿HGSRUWDERYH
NOTE