Hitachi NAS Platform 4000 Series - 10;100 Private Ethernet Ports

State Meaning
Medium
Flash
The server is available to host le services but is not currently doing so.
Flashes once e
very .8 seconds.
Fast Flash
The server is rebooting. Flashes 5 times per second.
O The server is not powered up.
Table 13 Sever Status LED (Amber)
State Meaning
Amber Critical failure and the server is not operational.
Slow Flash System shutdown has failed. Flashes once every three seconds.
Medium
Flash
The server needs attention, and a non-critical failure has been detected.
For e
xample, a fan or po
wer supply has failed. Flashes once every .8
seconds.
O Normal operation.
10/100 private Ethernet ports
The 10/100 Private Ethernet Network ports function as an unmanaged switch for the
private management network (refer to the Network Administration Guide for more
information on the private management network). These ports are used by the server
and other devices (such as an external SMU and other cluster nodes) to form the private
management network. There are no internal connections to the server from these ports;
instead, when joining a server to the private management network, you must connect
from one of these ports to the management interface port on the server.
The 10/100 ports operate at speeds of up to 100 megabits per second, and require the
use of a standard RJ45 cable connector.
The 10/100 Private Management Ethernet Network ports are labeled as shown next:
Figure 17 10/100 Private Management Network Ethernet Ports Label
Once connected, each 10/100 port has two indicator LEDs; one green and one amber.
These LEDs pr
ovide link status and network activity status information as follows:
10/100 private Ethernet ports
Chapter 4: Hitachi NAS Platform server components
Hitachi NAS Platform and Hitachi Unied Storage Series 4000 Hardware Reference 47