Hitachi NAS Platform 4040 - Shutting down the Server You Are Replacing

The server rmware version must match the failed server; otherwise, the server
cannot properly r
estore from the backup le. See the release notes and system
installation guide for release-specic requirements.
4. Navigate to Home > Server Settings > License Keys to check the license keys to
ensure you have the correct set of new license keys.
5. Record the following information:
■ IP addresses for Ethernet ports 0 and 1
■ Gateway
■ Domain name
■ Host name
Shutting down the server you are replacing
On the server that you are replacing:
Procedure
1. From the server console, issue the command: shutdown --ship --powerdown
Wait until the console displays Information: Server has shut down, and the
rear panel LEDs turn o.
The PSU and server fans continue to run until you remove
the po
wer cables from the PSU module. See the appropriate system component
section for more information.
Note: This specic
powerdown command prepares the system for both
shipping, and potential long-term, post-replacement storage.
2. Unplug the power cords from the power supplies.
3. Wait approximately 15 seconds, and then conrm the NVRAM status LED is o.
If the LED is ashing or xed, press and hold the reset button for ve seconds until
the LED starts ashing. The battery disables when you release the reset button.
Shutting down the server you are replacing
Appendix A: Server replacement procedures
Hitachi NAS Platform and Hitachi Unied Storage Series 4000 Hardware Reference 101