Hitachi NAS Platform 4040 - Shutting down the Servers You Are Replacing

The new server rmware version must match the failed server; otherwise, the
server cannot properly r
estore from the backup le. See the release notes and the
System Installation Guide for release-specic requirements.
4. Navigate to Home > Server Settings > IP Addresses to obtain:
■ Admin IP address and name
■ Cluster node IP address
The evs list command also displays these IP addresses.
Shutting down the servers you are replacing
On the servers that you are replacing:
Procedure
1. From the server console, issue the command: cn node shutdown --ship --
powerdown
(where node represents the targeted node)
Wait until the console displays Information: Server has shut down, and the
rear panel LEDs turn o. The PSU and server fans continue to run until you remove
the power cables fr
om the PSU module. See the appropriate system component
section for more information.
Note: This specic
powerdown command prepares the system for both
shipping, and potential long-term, post-replacement storage.
2. Unplug the power cor
ds from the power supplies.
3. Wait approximately 15 seconds, and then conrm the NVRAM status LED is o.
Shutting down the servers you are replacing
Appendix A: Server replacement procedures
Hitachi NAS Platform and Hitachi Unied Storage Series 4000 Hardware Reference 117