18
P5417086
No. Items Optional Function
Individual
Setting
Setting
Condition
Contents Setting
144 rE
Setback Activating Temp.
for Heat Mode
×
00
01
02
03
04
05
06
07
08
09
15.0°C
16.0°C
17.0°C
18.0°C
19.0°C
10.0°C
11.0°C
12.0°C
13.0°C
14.0°C
145 rF
Setback Activating Temp.
for Cool Mode
×
00
01
02
03
04
05
06
07
08
09
10
26.0°C
27.0°C
28.0°C
29.0°C
30.0°C
31.0°C
32.0°C
33.0°C
34.0°C
35.0°C
25.0°C
146 S1 Not Prepared - - Not Used (Use as 00 conditions)
147 S2 Not Prepared - - Not Used (Use as 00 conditions)
148 S3 Not Prepared - - Not Used (Use as 00 conditions)
149 S4 Not Prepared - - Not Used (Use as 00 conditions)
150 S5 Not Prepared - - Not Used (Use as 00 conditions)
151 S6 Not Prepared - - Not Used (Use as 00 conditions)
152 S7 Not Prepared - - Not Used (Use as 00 conditions)
153 S8 Not Prepared - - Not Used (Use as 00 conditions)
(*1): Temperatures for Floor Exposed Type & Floor Concealed Types are not offset. Setting temperature are used as
they are.
(*2): The “02”, “03”, “04” settings may not be available depending on the type of indoor unit.
When connecting multiple indoor units, do separate settings.
(*3): In Case of Duct Type Models
Setting RPI-FSN2 Model RPI(M)-FSN3 Model
00 Standard (Factory-Setting) Standard (Factory-Setting)
01 High Static Pressure High Static Pressure 1
02 Low Static Pressure High Static Pressure 2
(Please refer to the Installation Manual for Indoor Unit.)
(*4): Since it depends on the model, please refer to the Service Manual of each model.
(*5): “E1” to “E4”: Setting for the total heat exchanger
(*6): If the set temperature is changed and kept within the set time at “F4”, the temperature is automatically changed
to “F5” and “F6”. (If the set temperature is out of range at “F5” and “F6”, it is applied within the upper and lower
limits for the set temperature.)
(*7): Applicable to the fan, cooling and dry operation modes.
(*8): Applicable to the heating operation mode.
(*9): Operation is stopped by pressing the “
” (On/Off) button for three seconds.
(*10): When the unit is restarted by the controller, the temperature automatically changes to the setting temperature of
“F5” or “F6”.
(*11): Available only for 4-Way Cassette Compact Type, 2-Way Cassette Type, 1-Way Cassette Type.
(*12): Available only for 4-Way Cassette Type, 4-Way Cassette Compact Type, 2-Way Cassette Type, 1-Way Cassette
Type, Ceiling Type.
(*13): Turning “P4” to “01” can select thermistor (sensor) that can show temperature setpoint.
(*14): Function “01” can show up sensor temperature selected by “P3”.
To Next Page
Loading...
