Hitachi PC-ARFG-E - Installation Procedure

EN
2.1 INSTALLATION PROCEDURE
1 Insert the edge of the slotted screwdriver
into the groove at the bottom of the
holding bracket, push and turn the slotted
screwdriver to separate and remove the
controller from the holding bracket.
(iv)A-Groovepart
B-Approx.6mm
C-Slottedscrewdriver
D-Viewfromthebottomside
E-Wallmount
F-Tabsforattachmentofthecontroller
? NOTE
Donotinserttheslottedscrewdriverintothetab
partbesidethegroove.Thetabmaybedamaged
and the advanced color wired remote controller
cannotbeinstalled.
2 Attach the controller to the holding
bracket and connect the cable as follows:
• In Case of Exposing the Controller Cable
Fix the holding bracket onto the wall with
screws (accessory). (v)
Attach the stopper (plastic band) to the
cable at the inner side of the draw-out
hole.
(vi)B-Cable
C-Bandstopper(Field-supplied)
D-Draw-outhole
E-Lead the cable with its sheath peeled
throughthegroove
F-Peeltheinsulationattheendofthecable
and clamp the M3 solderless terminals
(eld-supplied)
• When Using Junction Box
- Prepare the optional eld-supplied
Implanted Junction Box.
- Feed the cable through the conduit
tubing in the wall.
(vii)G-Optional M size Junction box with
4xingtabs
H-Optional S size Junction box with
2xingtabs
I-M4screws(eld-supplied)
- Cut away the insulation at the end of
the cable and clamp the M3 solderless
terminals (eld-supplied). Connect the
terminals (J)
3 Attach the controller body to the mounted
holding bracket. Be careful not to pinch
the cable when attaching it.
4 After installation, peel away the protective
lm from the LCD screen. (viii)
Installation
PMML0564 rev.1 - 09/2021
2