3. Operation Method
10
A11766820A
3.7 Icon Description
The status of the remote controller is displayed on the operation screen.
NOTES:
•
It may not be displayed depending on the type of outdoor unit or indoor unit you are using.
•
No. Icon Description
A schedule timer is set.
Set the current time. Schedule timer operation is not possible.
The off timer is set.
The operation lock is set.
Displayed when using the central controller. Remote control operation is
restricted.
It is time to frostWash the heat exchanger.
It is time to clean the air filter.
A/C Air-conditioning operation is performed.
Vent.
THEX Vent.
Auto Vent.
Norm. Vent.
Ventilation, automatic ventilation, total heat ventilation, and normal ventilation
are operating.
**
o
C
Displays the room temperature. (*1)
SAG Elevating grille is not stored correctly.
Temporary Emergency operation is in progress.
Setback
When setback operation is enabled and the card key is removed (when no one is
present). (*2)
Purging In night purge progress.
Setback aborted Setback is aborted.
24 hour ventilation 24 hour ventilation is in progress.
Humidifier is run The humidifier is in operation.
Motion Sensor ON Indicates capacity savings by motion sensor control during operation or stop.
Radiant Sensor
In order to efficiently heat the room when the radiant temperature is low, the
wind direction and air volume are automatically controlled.
Cold draft restrained In order to prevent indoor temperature from being too low.
Noise reduction The operation noise reduction control of the outdoor unit is set.
FrostWash is complete Indicates the frostWash is performed.
IU temp. over range
FrostWash stopped
If the indoor temperature is out of the range of 59°F(15°C) to 86°F(30°C), no
frostWash is performed and the cancellation is displayed.
OU temp. over range
FrostWash stopped
If the outdoor temperature is out of the range of 34°F(1°C) to 110°F(43°C), no
frostWash is performed and the cancellation is displayed.
Sav
Sav: Low
Sav: Med
Sav: High
Either the outdoor capacity control, indoor rotation control, or intermittent
operation control is set.
Ext.Sav
Outdoor capacity control is set on the central controller or outdoor unit.
It does not light when the indoor rotation control or intermittent operation
control of the remote controller is set.
Main
This is the main remote controller setting.
Use the main remote controller to set the main power savings setting.
In the case of a single unit, the main does not light up.
Sub
Sub remote controller is set. Except for some power savings functions, the sub
remote controller cannot be set to save power.
Sub
There is no main remote controller.
Controls related to power savings and operation noise reduction may not
operate normally.
To Next Page
Loading...
