Hitachi PC-ARFG2-Z - Page 48

25. ESP Setting
A16381H9HF
45
Step3. Press " "or " " to select the setting and press "OK"
to conrm the setting.
Step4. Press " " to return to Step2 screen. Pressing " ", " ",
" ", or " " and press "OK" to set another indoor unit,
or press" " again to return to ESP Setting screen.
NOTES:
•
ESP Standard setting is the same as C5 of function selection.
•
When changing C5 of function selection, the change is valid immediately if ESP setting is standard mode.
Otherwise, the change will not be valid until ESP setting is changed to standard mode.
3. ESP Auto Setting
Step1. Select "ESP Auto Setting" on the ESP Setting screen
and press "OK".
Step2. Select the indoor unit by pressing " ", " ", " ", or " "
and press "OK".
(This screen is NOT displayed when only one indoor unit
is connected with the controller. In this case, Step3 is
displayed.)
Step3. Select "Yes" and press "OK" to start auto ESP.
Step4. In Checking ESP screen,
a. wait for the "Completed" screen shows,
select "Continue" and return to Step 2 to select
another indoor unit for auto ESP. Or select "Complete"
to return to Step1.
OK
Select Back
ESP Standard Setting
Hi speed 1
Hi speed 2
Standard
ESP Setting
ESP Manual Setting
Display ESP Setting
ESP Auto Setting
ESP Standard Setting
OK
Select Back
ESP Auto Setting
01-00
ALL
01-01
01-02
OK
Enter Back
01-03
ESP Auto Setting
OK
Select Back
All
Start Auto ESP now?
Yes Cancel
ESP Auto Setting
OK
Abort Back
Checking ESP
ESP Auto Setting
OK
Select Back
Completed.
Continue Complete