3 Press “ ”. The elevating grille starts lowering.
• Once “ ” is pressed, the elevating grille lowers to the
specied height.
• If “ ” is pressed once again, the elevating grille lowers by
50cm from the present height. (When “ ” is pressed each
time, the elevating grille lowers respectively by 50cm.)
• To stop the elevating grille, press “ ”.
UPDW
Elevating Grille:All
Press to raise/lower grille
RTN.
4 When the cleaning is nished, press “ ”. The elevating
grille starts rising. The grille will be set inside the air panel
and stopped moving after 3 seconds. (If the air inlet grille is
inclined at this time, press “ ” again. An inclination may be
corrected).
UPDW
Elevating Grille:All
Press to raise/lower grille
RTN.
5 Press “ ” (return). The screen will return to (2). If
necessary, set the elevating grille for other indoor units). To
nish the setting, press “ ” (return) again. The screen will
return to the menu. If “ ” (return) is pressed once again, the
screen will return to the normal mode.
UPDW
OK
Elevating Grille
All
00-00
01-01
02-02
ENT
TN.SEL.
OK
? NOTE
If the number of indoor unit connected with the remote control switch is
1 (one), the screen will return to the normal mode after “ ” (return) is
pressed.
14.4 SIMPLE TIMER OPERATION
This function is used to start or stop the unit operation at the
setting time.
The timer operation contents can be set from “Once” or
“Everyday”.
1 Select “Simple Timer” from the menu and press “OK”. The
simple timer setting will be displayed.
Menu
Schedule Timer
Simple Timer
Function 3
Elevating Grille
01
/
03
Filter Sign Reset
15:10(Fri)
ENT
TN.SEL.
OK
OK
OK
? NOTE
If the present time has not been set yet, automatically “Set Date/Time” will
be displayed. Refer to “14.11 Adjusting date/time” section.
2 Press “ ” or “ ” to select the setting items. The setting items
are displayed “Timer Ope.”, “ON Time” and “OFF Time”.
Simple Timer
Timer Ope.
Not Used
ON Time
- - : - -
OFF Time
- - : - -
15:10(Fri)
ENT
TN.SEL. ADJ
OK
OK
3 Press “ ” or “ ” to set each setting content for the selected
item. When “Timer Ope.” is selected, the setting contents
are switched in order of “Not Used” “Once”
“Everyday” by repeatedly pressing “ ” or “ ”. When “ON
Time” or “OFF Time” is selected, the setting time can be set
every 30 minutes by pressing “ ” or “ ”. Press and hold “ ”
or “ ”, the setting time can be continuously indicated.
Simple Timer
Timer Ope.
Everyday
ON Time
08 : 30
OFF Time
- - : - -
15:10(Fri)
ENT
TN.SEL. ADJ
OK
OK
OK
? NOTE
If “Once” of the timer operation setting is selected, the setting content
will be automatically changed to “Not Used” after “Once” timer operation.
4 Press “OK” to nish the simple timer setting. The
conrmation screen will be displayed.
Set timer operation?
Simple Timer
Yes No
SEL. ENT
TN.
15:10(Fri)
OK
OK
ENGLISH
MENU OPERATION
PMML0404A rev.1.1 - 06/2022
25