Hitachi PC-ARFP1E - Schedule ON;OFF Setting; Individual Louver Setting

14.5.3 Schedule ON/OFF setting
This function is used to deactivate the schedule operation
temporarily.
The schedule operation will not be carried out when “OFF” is set
in this function.
This function is used to apply for long period of holidays.
1 Select “Schedule Timer” from the menu and press “OK”.
Menu
Schedule Timer
Simple Timer
Function 3
Elevating Grille
01
/
03
Filter Sign Reset
15:10(Fri)
ENT
.R
TN.SEL.
OK
OK
OK
2 Select “Schedule ON/OFF” by pressing “ ” or “ ” and press
“OK”. The conrmation screen will be displayed.
OK
Schedule Timer
Schedule ON/OFF
Holiday Setting
Day/Time Setting
15:10(Fri)
ENT
.R
TN.SEL.
OK
OK
3 Select “Yes” by pressing “ ” or “ ” and press “OK”. The
schedule ON/OFF setting will be conrmed and the screen
will return to the normal mode.
“ ” will be turned on when the setting of schedule operation
is valid.
“ ” will be turned o󰀨 when the setting of schedule operation
is invalid.
OK
Turn ON schedule function?
Schedule ON/OFF
Yes No
SEL. ENT
.R
TN.
15:10(Fri)
OK
OK
? NOTE
When the setting of schedule operation is invalid, the schedule operation
will not be activated.
14.6 INDIVIDUAL LOUVER SETTING
14.6.1 Setting
This setting is available only for the indoor unit adopting the
individual louver. The each louver angle can be set individually.
? NOTE
• This function is available only when the indoor unit corresponds to
the individual louver.
• This function cannot be set when the unit is stopped.
• The fan speed will be changed to “LOW” while this function is being
set. (After the setting is completed, the unit operation will be back to
normal).
• As for “Start-up of Heating Operation”, “During Defrost Operation”
and “Activation of Thermo-Controller”, all the louver angles will be
xed at horizontal position automatically even when this function is
activated.
• This function will not be available if 2 (two) remote control switches
(including multifunctional remote control switch + wireless remote
control switch) are used.
• With one multifunctional remote control switch, the maximum of 4
(four) indoor units can be set for this function.
1 Select “Louver Setting” from the menu and press “OK”.
The individual louver setting menu will be displayed.
Menu
Motion Sensor Setting
Total Heat Exchanger SET
VENTI
Louver Open/Close
02
/
03
Louver Setting
15:10(Fri)
ENT
.R
TN.SEL.
OK
OK
OK
2 Select “Louver Setting” from the individual louver setting
menu and press “OK”.
OK
Cancel INDV Louver SET
Louver Setting
Louver Setting
ENT
.R
TN.SEL.
? NOTE
If the number of indoor unit connected with the remote control switch is 1
(one), (4) will be displayed after the procedure (2).
MENU OPERATION
PMML0404A rev.1.1 - 06/2022
28