Hitachi PC-ARFP1E - Adjusting Date;Time

6 The display is switched “Running”, “Stand-by” and “Stop” in
order by pressing “ ” or “ ” and change the setting.
If other settings are not required, move to procedure (9).
Motion Sensor Setting
Sensor
ON
If absent
Running
Check interval
30MIN
ENT
.R
TN.SEL. ADJ
OK
OK
7 Press “ ” or “ ” and select “Check interval”.
Motion Sensor Setting
Sensor
ON
If absent
Running
Check interval
30MIN
ENT
.R
TN.SEL. ADJ
OK
OK
8 The display is switched “30MIN”, “60MIN”, “90MIN”,
“120MIN” and “180MIN” in order by pressing “ ” or “ ” and
change the setting.
If other settings are not required, move to procedure (9).
Motion Sensor Setting
Sensor
ON
If absent
Running
Check interval
30MIN
ENT
.R
TN.SEL. ADJ
OK
OK
9 Press “OK” after the setting is completed. The conrmation
screen will be displayed. Select “Yes” by pressing “ ” or
“ ” and press “OK”. The motion sensor setting will be
conrmed and the screen will return to the normal mode
(operation mode indication).
A/C
LOUV.
Motion Sensor is activated
LOUV. ADJ
MODE SPEED
HEAT
MED
TEMP
Meeting Room
OK
Save changes?
Motion Sensor Setting
Yes No
SEL. ENT
.R
TN.
OK
OK
OK
14.11 ADJUSTING DATE/TIME
This function is used to adjust the date and time.
Periodic time setting is recommended. (Clock accuracy:
di󰀨erence within +70 seconds by month).
As for this remote control switch, the clock can work up to 72
hours when power failure occurs. Reset the date and time if the
remote control switch remains without power supply for longer
than 72 hours or main power supply is OFF for long time.
1 Select “Adjusting Date/Time” from the menu and press “OK”.
Adjusting Date/Time
Fri
Function 13
RTN.SEL.
ENT.
OK
OK
2 Press “ ” or “ ” and select “yy/mm/dd/hh/mm”.
3 Press “ ” or “ ” to change the setting. Press or keep
pressing “ ” or “ ” to adjust numbers.
4 After the setting is completed, press “OK” and the
conrmation screen will be displayed.
Adjusting Date/Time
2011
01 01 00 :19
RTN.
SEL.
ENT.
OK
OK
OK
5 Select “Yes” by pressing “ ” or “ ” and press “OK”. The
setting will be conrmed and the screen will return to the
normal mode.
Adjusting Date/Time
Set date/time?
RTN.SEL.
ENT.
OK
OK
ENGLISH
MENU OPERATION
PMML0404A rev.1.1 - 06/2022
33