Hitachi PC-ART - Page 15

15
INSTALLATION MANUAL
7. By pressing the () DAY / SCHEDULE switches, the SET and SCHEDULE indicators go out and the
mode returns to normal.
:
S
NEXT
SCHEDULE
OFF
:
Mon
 Defi ning the schedule to be applied
1. Hold down the () DAY/SCHEDULE switches for more than 3 seconds and the SET indicator appears.
All the days and schedule numbers are indicated.
:
SET
Mon Tu e
Wed
Thu Fri
Sat
Sun 1234S
ON
4
OFF
:
2. Press the () DAY/SCHEDULE switches until the day you wish to set blinks. When pressed, the day
blinks [Mon]  [Tue] …  [Sun] [Mon~Sun]  [Mon~Fri]  [Sat, Sun]  [Mon]... If several days are
blinking, the same setting will be applied to all the days.
3. Press the (
) DAY switch until the schedule number you wish to set blinks.
:
SET
Mon Tu e
Wed
Thu Fri
Sat
Sun 1234S
ON
4
OFF
:
4. Press the () SCHEDULE, and the SCHEDULE indication appears. Then the schedule number indicated
in step 3 is applied to the days set in step 2. Press the OK switch to activate or deactivate the schedule. If the
schedule is activated, the word SCHEDULE is lit up.
:
SET
Mon Tu e
Wed
Thu Fri
Sat
Sun 1234S
SCHEDULE
ON
4
OFF
:
5. Press the TIMER switch and the mode returns to normal.
:
Mon
NEXT
SCHEDULE
OFF
:
 Cancelling the timer
In the normal mode, hold down the () DAY / SCHEDULE switches for more than 3 seconds.
The NEXT SCHEDULE indicator blinks. (Cancellation of all the timer)
:
Mon
1234S
NEXT
SCHEDULE
ON
:
While the timer is in cancellation mode, hold down the () DAY / SCHEDULE switches for more
than 3 seconds. NEXT SCHEDULE is indicated. (Timer activation)
:
Mon
1234S
NEXT
SCHEDULE
ON
:
 Setting the temperature shifts (energy saving mode)
1. Set the ON/OFF operation as in steps 1 and 2 of the “Setting the timer” section, and then select “S” as the
schedule number.
:
1234S
SCHEDULE
ON
4
OFF
:
SET
2. Set the ON/OFF operation in steps 4,5 and 6 of the “Setting the timer” section, and set the ON/OFF time. The
temperature setting is then indicated.
:
1234S
SCHEDULE
ON
4
OFF
:
SET
3. Select the temperature shift with the  switches. “3” or “5” can be selected. If the reset switch is pressed at
this time, the temperature shift is not set and the indication “- -“ appears. When the TIMER switch is pressed,
the temperature is indicated and the mode changes to schedule number selection.
:
1234S
SCHEDULE
ON
4
OFF
SET
:
4. When the TIMER switch is pressed, the SET and SCHEDULE indicators go out and the mode returns to
normal.
:
S
NEXT
SCHEDULE
OFF
:
Mon
 NOTE:
1. When this operation is performed, the temperature shift indicator changes.
2. When this operation is performed, the temperature setting of the CSNET NET WEB or PSC-A64S has a normal range, while the remote
control setting may be changed to a new range.
3. The increase or decrease in the temperature setting during the scheduled time (±3 ºC or ±5 ºC) varies according to the operation mode.
- If the system is operating in FAN, COOL or DRY mode, the temperature variation is + .
- If the system is operating in HEAT, mode, the temperature variation is - .