8
INSTALLATION MANUAL
2.4. INSTALLATION PROCEDURES
1. Insert the edge of the fl at head screwdriver into the dent parts at the bottom of the holding bracket, push and turn the screwdriver and remove
the controller from the holding bracket as shown in the next fi gure.
2. Attach the controller to the holding bracket as follows.
2.1. In case of exposing Remote Control Cable.
. Fix the holding bracket onto the wall as shown below.
. Attach the stopper to the cable at the inside
of the draw-out hole.
. Lead the cable with its sheath peeled through the groove.
. Peel the insulation at the end of the cable and clamp
the M3 solderless terminals.
2.2. When Using Switch Box.
. Run the cable into Field-Supplied JIS Box
(JIS 8336 -1998).
The following 5 types are available.
1. Switch Box for 1 Controller (without Cover).
2.
Switch Box for 2 Controllers (without Cover).
3. Switch Box for 1 Controller (with Cover).
4. Switch Box for 2 Controllers (with Cover).
5.
Outlet Box (with Cover).
Run the cable through the conduit tube in the wall.
. Fix the holding bracket to the switch box.
. Peel the insulation at the end of the cable and clamp
the M3 solderless terminals.
. Mounting procedures.
1. Insert the hooks of the
controller to the holes on the
top of the holding bracket.
2. Push the lower part toward
the holding bracket.
3.
When the click sound is
heard, the controller is
attached to the holding
bracket and the mounting
work is fi nished.
CAUTION:
Pay attention so that the cable may not be slack. If the cable is
slack as shown in the above fi gure, the cable cord (especially the
naked part) may be clamped at the hole and it may cause a faulty
operation.
Controller
Dent Part
Holding Bracket
Dent part
Screwdriver
Dent part
Screwdriver
Holding
Bracket
Holding
Bracket
Dent part
Fix the holding bracket
with the mark “UP”
upward
Screw
(Accessory)
Band (Field-
Supplied)
Cable
Remocon
Remocon
A
B
Connect the terminals
To Next Page
Loading...
