Simultaneous Run/Stop for Block
1 Select the target block from the touchscreen display to set simultaneous Run/Stop operation.
2 Tap “Run by Block” to run all the groups in the selected block simultaneously.
Tap “Stop by Block” to stop all the groups in the selected block simultaneously.
(1)
(2)
3 The conrmation window is displayed. Tap “OK”. for simultaneous operation of all the groups (all the indoor units) in
the selected block connected to the central station. Tap “Cancel” to cancel this command.
(3)
NOTE
The commands to run by block and stop by block have no ef-
fect on the groups specied in “Exception Setting of Run/Stop
Operation”.
5 Centralised remote controls
PSC-A32MN
TCGB0106 rev.0 - 12/2014
318
To Next Page
Loading...
Need help?
General
