External Input/Output Setting
1 Select “External Input/Output Setting” on the screen of “Service Menu”.
Back
Service Menu
25/01/2010 (Mon) 10:20
Group Register
Optional Function
Setting
Exception Setting
of Run/Stop
Operation
External
Input/Output Setting
Exception
External Input
Demand Function
Setting
Button Setting
Alarm History
Checking
Connection
Restore Setting
Contact Info.
Register
(1)
NOTE
This function cannot be selected when the air conditioner(s) is operated or the external input signal is input to the external input terminal
1 or 2.
2 Select the function by tapping the button for each external input/output terminal as follows:
“Input 1”, “Input 2”, “Output 1” and “Output 2”
The selected function button colour is changed.
3 Tap “Done” to nish this setting. The screen is returned to “Service Menu”.
Control Mode
Disable
Disable
Input 1
Output 2
Input 2
Output 1
All Run/Stop
(Level)
All Run
(Pulse)
All Stop
(Pulse)
Emergency Stop
Demand
Function
All Run/Stop
(Level)
All Run
(Pulse)
All Stop
(Pulse)
All Run
External
Output Alarm
All Run
External
Output Alarm
Done
Output Setting
Emergency Stop
No Settings
No Settings
No Settings
No Settings
25/01/2010 (Mon) 10:20
(2)
(3)
.
The external input/output each of two terminals are available. The assigned functions are shown in below.
Input and Output Connection Function
Input 1 TB3 1-2 Pin
All Run/Stop (Level)
All Run (Pulse)
All Stop (Pulse)
Emergency Stop (Level)
Demand Function (Input 1 only)
No Setting (Factory Setting)
Input 2 TB3 2-3 Pin
Output 1 TB3 4-5 Pin
All Run
All Alarm
No Setting (Factory Setting)
Output 2 TB3 5-6 Pin
5 Centralised remote controls
PSC-A64GT
TCGB0106 rev.0 - 12/2014
277
5
To Next Page
Loading...
