Hitachi RA-08HV - Installation Bracket and Water Drainage Assembly; Parts List for Installation; Assembly Guidelines

~ 14 ~
How to assemble the water drainage
Names of parts to be installed
Number
Name
Quantity
①
Main bracket
1
②
Cantilever
2
③
Caulking foam
1
④
Lockout screw
6
⑤
Lockout nut
6
⑥
Hex head screw
2
⑦
Steel nail
2
⑫
Expansion bolt
2
⑬
Caulking styrofoam
plate
1
⑭
Special screw
2
⑮
Self-tapping screw
6
⑯
Wood screw
2
⑰
Plug
2
Quantity will be based on the
actual accessory kit supplied.
Installation guidelines
(1) Assemble the installation bracket according to Step (1) –(5) of How to assemble the installation bracket
depending on the window condition and adjust the bracket’s level so that the outdoor side will be lower 10~15 mm
than the indoor side.
(2) Refer to (Figure 1) and push the unit body onto the Main bracket. Remove the front cover. Be sure to tighten the hex
head screws⑥.
(3) Replace the front cover. Plug the power cord into the receptacle. Connect the outdoor Water drain elbow with the
Water drainpipe. Now you have completed installation of the air conditioner.
HOW TO AS S EM BL E T HE INSTALL ATION BR AC K ET AND T H E WAT ER D R AIN AGE
機 種
高（mm）
寬（mm）
深（mm）
Insert the Drain Elbow into the
Base Drain Hose.
Connect the Water Pipe Drain to
the other end of the Drain Elbow
⑧ Flat washer 4
⑨ Angle bracket 2
⑩ Fixing bracket 2
⑪ Screw 2
Base Drain Hose
Drain Elbow
Water Pipe Drain
15
16
17
9
1
7
3
8
2
4
5
6
14
10
11
12
13
1
2