– 25 –
Step 3: Copy and cancel the reservation schedule.
[Delete one day reservation]
1. Press (WEEKLY) button to select Mode A or Mode B.
2. Press
(WEEKLY) button for 3 seconds to start editing the
reservation schedule.
3. Press
(DAY) button to select a day of the week to edit.
4. Press
(DELETE) button for about 10 seconds. Reservations for all
program numbers will be deleted.
● If press for a short time, reservation for one program number will be
deleted.
5. After deleting, press
(SEND) button while directing the remote
controller towards the indoor unit for about 3 seconds. Timer lamp on the
indoor unit will blink rapidly.
After beep sound emitted from indoor unit, TIMER lamp will light up.
Please ensure that the TIMER lamp lights up.
● Reservation will not change if (SEND) button is not pressed.
1
1
2
NOTE
● If all reservations in the remote controller were deleted and pressed (SEND) button, no signal will
be transmitted to indoor unit. TIMER lamp will remain off and no changes will be done to the reservations
stored in the indoor unit.
3
2
4
5
WEEKLY TIMER OPERATION
[Delete Mode A or Mode B]
1. Press
(WEEKLY) button to select Mode A or Mode B.
2. Direct the remote controller towards the indoor unit and press
(DELETE) button for about 10 seconds while Mode A or Mode B display
blinks.
After beep sound emitted from indoor unit, reservations for Mode A or
Mode B will disappear.
ENGLISH
– 26 –
INFO FUNCTION
● By pressing (INFO) button, temperature around remote controller and monthly power consumption will
be displayed on the remote controller.
● After changing the batteries, direct the remote controller towards the indoor unit and press (INFO) button.
Current calendar and clock will be transmitted from indoor unit.
● In order to receive information from indoor unit, the distance between remote controller and receiver of indoor
units is within 2 meters.
■ To check temperature around remote controller
■ Current calendar and clock can be retrieved from indoor unit
■ To check monthly power consumption
Press (INFO) button.
Temperature will be displayed for 10 seconds.
Direct the remote controller towards the receiver of indoor unit (within 2
meters in front of indoor unit) and press
(INFO) button. Wait for 2
seconds for signal transmission.
Once received the current calendar and clock, check whether they are correct
or not by pressing
(CLOCK) button.
● If there is no power supply to indoor unit or calendar and clock have not been
set, INFO function cannot be used for sending or receiving information.
Direct the remote controller towards the receiver of indoor unit (within 2
meters in front of indoor unit) and press
(INFO) button. Wait for 2
seconds for signal transmission.
While temperature around remote controller is displayed, press
(INFO)
button repeatedly. The display will show as below:
this month power consumption amount for heating
last month power consumption
amount for heating
this month power consumption amount for cooling last
month power consumption amount for cooling
temperature around remote
controller this month power consumption amount for heating ...... cyclically.
● If indication is not given, bring remote controller closer to the receiver of
the indoor unit.
● Indicated value shall be regarded as a guide only.
NOTE
● In case failure occurs to the air conditioner, by pressing (INFO) button, an error code will be displayed.
Direct the remote controller towards the receiver of indoor unit (within 2 meters in front of indoor unit)
and press
(INFO) button. Wait for 2 seconds for signal transmission.
An error code will be displayed.
Call service center and inform the error code.
● Info Function to check monthly power consumption.
During installation, in case of power failure or breaker ON / OFF, ensure to set the clock and calendar for each
indoor unit (unit in standby mode or auto restart), for single or multi connection, by pressing
(START / STOP)
button.
Failure to do the above,monthly power consumption amount will not be displayed on the remote controller.
1
To Next Page
Loading...
