EasyManua.ls Logo

Hitachi RAC-25RPA - Dehumidifying Mode; Heating Mode

Hitachi RAC-25RPA
117 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...















RA
RAC-25FPAF- 5RPA /2
RA RAC-35FPAF-35RPA /
75
DEHUMIDIFYING MODE
HEATING MODE
Q1
A1
A1
A2
A3
Q2
Q1
Q2
Q3
A2
AQ
Sound of running water is heard from
indoor unit during dehumidifying.
Cold air comes out during a
dehumidifying operation.
The operation does not stop even by
setting the temperature higher than
room temperature on the remote
controller.
The circulation stops
occasionally during Heating
mode.
It occurs during defrosting
Wait for 5 -10 minutes until
the condenser is defrosted.
When the fan speed is set at
HIGH or MED, the flow is
actually Weak.
At the beginning of heating,
the fan speed remains
LOW for 30 seconds.
If HIGH is elected, it
switches to LOW and again
to MED after additional
30 seconds.
Heating operation stops while
the temperature is preset at
"30".
If temperature is high in the
outdoor, heating operation
may stop to protect internal
devices.
Normal sound when refrigerant flows in pipe.
To improve the dehumidification efficiency performs
quiet fan operation. Therefore the air is cold and it is
not a malfunction.
It sets to perform dehumidifying operation by setting
the temperature slightly lower than remote controller
setting.
3 3
A4
Q4
When the heating operation is
started, the indoor fan not start.
This is because the
drive the fan until the
up and warm air blows.
preheating device is
working. lt will not start to
refrigerating cycle warms

Other manuals for Hitachi RAC-25RPA

Related product manuals