EasyManua.ls Logo

Hitachi RAK-18NH5 - Page 46

Hitachi RAK-18NH5
371 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Ð 0229 Ð
Ð1










    !  "#$%&
¥ The air cleansing and deodorizing filters can absorb even minute dust
particles.The filterÕsantibacterial functionpreventsgrowthofmicroorganisms
in the filter. The aircleansingand deodorizing filters also addairpurification
to the unitÕs normal operationto offer a clean andcomfortable environment.
¥ When installing the air cleansing and deodorizing filters, remove the air
filters and attach them onto the hooks of the front cover frame.
¥ The cooling capacity is slightly weakened and the cooling speed becomes
slower when the air cleansing and deodorizing filters are used. So, set the
fan speed to ÒHIGHÓ when using it in this condition.
¥ The air cleansing and deodorizing filters is washable and reusable up to 20
times by using vacuum cleaner or water rinse under running tap water.
 
Air cleansing and
deodorizing filters
Ð1
'()*+,-
Press the hook found at the tip of the resin band
installed inside the front panelÕs right section to
remove the resin band.
. /    01   
¥Besure to use both hands to grasp the front panel when removing it or attaching it.
¥ The front panel may be installed up or down to suit user preference.
2 0  3    
¥ Activating air conditioner drying will keep the interior of the indoor unit
dry and prevent mold formation.
¥Turn off the circuit breaker.
Pull the front panel down toward you and once
fully open, pull it to remove.
44567+,-
Attach three front panel bearings to the axis of
the front cover. (Set the hook to face up.)
Insert the tip of the resin band into the hole of the
protrusion inside the right section of the front
panel.
Air blow
Resin band
Hook
Front cover
Front panel
Resin band
8    
The front panel can be washed in water. It can be kept clean at all times.
¥Front panel can be removed and washed in water. Gently clean the
front panel using a soft sponge.
¥ When the air conditioner is to be cleaned without removing the front
panel, clean both the body and remote controller with a dry soft cloth.
¥ Wipe off water completely. If water remains on the display section or
light receiver section, this could cause a malfunction.
B
E
N
Z
I
N
E
T
H
I
N
N
E
R
A
C
I
D

¥Donot splash or direct water to the body of the unit when cleaning it as this may
cause short circuit.
¥ Never clean with hot water (above 40¡C), benzine, gasoline, acid, thinner or a
brush, because it will damage the plastic surface and the coating.
1
2
1
2
- 46 -

Related product manuals