ENGLISH
MODEL
RAR-5E2
Remote Controller Manual
Remote Controller manual
Page 1~27
To obtain the best performance and ensure years of trouble free use, please read this instruction manual completely.
– 2 –
PREPARATION BEFORE OPERATION
1. Slide the cover to take it off.
2. Install two dry batteries AAA.LR03 (alkaline).
The direction of the batteries should match the
marks in the case.
1. Choose a place from where the signals can reach the unit.
2. Fix the remote controller holder to a wall, a pillar or similar
location with the provided screws.
3. Place the remote controller in the remote controller holder.
Remote controller
Screws
Remote controller holder
Ƶ To install the batteries
3. Replace the cover at its original position.
Ƶ To fix the remote controller holder to the wall
NOTE
Notes on batteries
ƽ When replacing the batteries, use batteries of the same
type, and replace both old batteries together.
ƽ When the system is not used for a long time, take the
batteries out.
ƽThe batteries will last for approximately 1 year. However, if
the remote controller display begins to fade and degradation
of reception performance occurs within a year, replace both
batteries with new size AAA.LR03 (alkaline).
ƽThe attached batteries are provided for the initial use of
the system.
The usable period of the batteries may be short depending
on the manufactured date of the air conditioner.
Notes on the remote controller
ƽNever expose the remote controller to direct sunlight.
ƽDust on the signal transmitter or receiver will reduce the
sensitivity. Wipe off dust with soft cloth.
ƽSignal communication may be disabled if an electronic-
is in the room. Consult the shop if that is the case.
ƽ If the remote controller signals happen to operate another
appliance, move that appliance to somewhere else, or
consult the service shop.
ƽ When the remote controller is not in use, please close the
slide cover to prevent failure.
To Next Page
Loading...
