MANUAL OPERATION [Heating
Dehumidify
Cooling]
Please use under below condition when you want to set the function mode, room temperature and
fan speed by manually.
1
OPERATION MODE SELECTION
Every time you press the button, the mode will change as the below
sequence
(Auto) → (Heat) → (Dry) → (Cool)
2
ROOM TEMPERATURE SETTING
Up
Down
The cooling operation does not start if the
temperature setting is higher than the current
room temperature.
3
FAN SPEED SETTING
Every time you press the button, fan speed will change as
below sequence.
HEATING: AUTO → HIGH → MED → LOW
COOLING: ( → → → )
DEHUMIDIFYING: LOW (FIXED)
: ( )
4
Press the (START/STOP) button
Operation start with a signal received sound “beep”.
Press the (START/STOP) button
As the settings are stored in memory in the remote control unit, you
only have to press the (Start/Stop) button in order to use the
same setting next time.
STOP
HEATING
Outdoor Temperature
24 below
DEHUMIDIFYING
Room Temperature
16 above
COOLING
Outdoor Temperature
21 above
°C
Heating 20~24
°
C
Dehumidify 20~26
°
C
Cooling 25~28
°
C
Recommend Temperature
HITACHI
°C
HITACHI
°C
HITACHI
°C
}
HITACHI
°C
− 12 −
°C °C °C
To Next Page
Loading...
