MAINTENANCE
INSTALLATION METHOD
REMOVING METHOD
Air filter
Before the cleaning, stop operation and disconnect the power supply.
1. AIR FILTER
Clean the air filter, as it removes dust inside the room. In case the air filter is full of dust, the air flow
will decrease and the cooling capacity will be reduced. Further, noise may occur. Be sure to clean the
filter following the procedure below.
PROCEDURE
CAUTION
Do not wash with hot water at more than 40
°
C. The filter may shrink.
When washing it, shake off moisture completely and dry it in the shade; do not expose it directly
to the sun. The filter may shrink.
Open the front panel and remove the filter
Gently lift and remove the air cleansing and
deodorizing filters from the air filter frame.
1
Set the filter with "FRONT" mark facing
front, and slot them into the original state.
After attaching the filter, push the front panel
at three arrow portions as shown in figure
and close it.
3
Vacuum dust from the air filter using
vacuum cleaner. If there is too much dust,
rinse under running tap water and gently
brush it with soft bristle brush. Allow filters to
dry in shade.
2
!
− 20 −
To Next Page
Loading...
