Hitachi RAS-09G4 - Page 56

– 61 –
1) When the “Automatic”
operation mode is
selected, “Automatic”
does not change by
pressing the fan speed
select button.
2) The room temperature
setting is not displayed.
3) Pressing the room
temperature control button
develops transmit mark
“ ” and sounds a
receive sound but does
not display the room
temperature setting.
Q14
1) When the operation
mode is “Automatic”, the
fan speed is
automatically fixed to
“Automatic”.
2) At an “Automatic”
operation, the room
temperature setting is not
displayed.
The room temperature is
automatically set as
follows.
At cooling
Set at 27°C.
At dehumidifying
Set to a temperature
slightly lower than the
room temperature.
3) At an “Automatic”
operation, the room
temperature setting is not
displayed.
However, every pressing
“ ” or “ V ” button
changes 1°C within the
range of:
27±3°C when cooling.
A14
Wireless remote controller
The room temperature
sensing thermistor in the
indoor unit detects the room
temperature and, according
to the particular temperature,
automatically performs
“Cooling” or “Dehumidifying”
operation.
The value indicated not at an
“Automatic” but manual
operation is not the actual
room temperature but the
room temperature setting.
When the room temperature
setting is “16”, pressing the
room temperature control
button “ V ” causes no
transmission. At “32”,
pressing “ ” causes no
transmission either.
Q15
The room temperature is
settable within the range of
16 - 32 and not beyond.
A15
The timer cannot be set.
Q16
Is the current time set?
The timer cannot be set
unless the clock is adjusted
correctly.
A16
V
The current time disap-
pears soon.
Q17
The current time disappears
soon and the timer settting
indication takes a
precedence.
A17
When setting the current time,
its indication blinks for
approximately 3 minutes.
V