– 15 –
ENGLISH
DEHUMIDIFYING OPERATION
Press the FUNCTION selector so that the display indicates (DEHUMIDIFY).
Press the
(FAN SPEED) button to select LOW and SILENT.
Press the
(START/STOP) button.
■ When you want to change the operation mode, please use the FUNCTION
selector.
■ Set the desired temperature is available.
■ You also can use the FUNCTION selector to select this operation.
• Dehumidifying takes place with a target temperature which is slightly lower than the room temperature setting.
(However, target temperature is 16°C for a temperature setting of 16°C.) If the room temperature becomes lower
than the target value, operation stops. If the room temperature becomes higher than the target value, operation
restarts.
• The preset room temperature may not be reached depending on the number of people present in the room
conditions.
Use the device for dehumidifying when the room temperature is over 16°C. When it is under 15°C, the dehumidifying
function will not work.
1
START
STOP
RAS-10_14JH3_Ope_EN 05/12/2008, 04:43 pm15
– 16 –
Set the desired room temperature with the TEMPERATURE buttons (the display
indicates the setting).
The temperature setting and the actual room temperature may vary somewhat
depending on conditions.
COOLING OPERATION
Set the desired FAN SPEED with the (FAN SPEED) button (the display
indicates the setting).
(AUTO) :
The FAN SPEED is HI at first and varies to MED automatically
when the preset temperature has been reached.
(HI) : Economical as the room will become cool quickly.
(MED) : Quiet.
(LOW) : More quiet.
(SILENT) : Silent.
Press the (START/STOP) button.
■ Direct selection
■ Manual selection
Press the FUNCTION selector so that the display indicates (COOL).
Press the (COOL) button. Operation start with a beep at previous COOL
mode.
Press the (START/STOP) button. Cooling operation starts with a beep. Press
the button again to stop operation. The cooling function does not start if the
temperature setting is higher than the current room temperature (even though
the
(OPERATION) lamp lights).
The cooling function will start as soon as you set the temperature below the
current room temperature.
■ As the settings are stored in memory in the remote controller, you only have to press
the
(START/STOP) button next time.
Use the device for cooling when the outdoor temperature is -10 to 42°C.
If humidity is very high (over 80%) indoors, some dew may form on the air outlet grill of the indoor unit.
STOP
1
2
1
START
STOP
3
RAS-10_14JH3_Ope_EN 05/12/2008, 04:43 pm16
To Next Page
Loading...
