Q5
The micro-mesh and stainless steel
filter remain dirty.
・There may occur cleaning unevenness depending on
the operating environment. In that case, clean the
micro-mesh and stainless steel filter.
・ If you wish to conduct "manual filter cleaning" at a
desired time while filter cleaning is disabled, then dirt
may remain depending on the amount of dust or dirt.
A5
The cleaning unit has stopped midway.
Q4
・Didn't you open the front panel while cleaning the filter?
(The "clean lamp" will go on for 1 second and go
dimmed for 1 second.)
・After servicing the filter cleaning wiper, did you move
the cleaning unit to the right end by remote control?
・Are the micro-mesh, stainless steel filter, dust catcher,
and filter cleaning wiper, and wiper cover correctly
installed?
(The "clean lamp" will go on for 4 seconds and off for 1
second.)
A4
– 107 –
To Next Page
Loading...
