– 29 –
ATTACHING THE AIR CLEANSING AND DEODORIZING FILTERS
1
Open the front panel.
● Be sure to hold the button sides on the left and
right of the front panel with both hands and pull
up the front panel forward.
2
● Slightly lift the filter and release the claws (2
locations) at the lower part of the front cover
and remove the filter from the lower side.
3
Attaching the air cleansing and deodorizing
filters to the filter.
● Attach the air cleansing and deodorizing filters
to the frame by gently compress its both sides
and release after insertion into filter frame.
4
Attach the filters.
● Attach the filters by ensuring that the surface
written “FRONT” is facing front.
● After attaching the filters, push the front panel
at three arrow portion as shown in figure and
close it.
RAS-30CNHZ2
● The cooling capacity is slightly weakened and the cooling speed becomes slower when the air
cleaning and deodorizing filter is used. So, set the fan speed to “HIGH” when using it in this
condition.
● Air cleansing and deodorizing filters is washable and reusable up to 20 times by using vacuum
cleaner or water rinse. Type number for this air cleaning filter is <SPX-CFH5>. Please use this
number for ordering when you want to renew it.
NOTE:
Claws
Frame
Air cleansing
and
deodorizing
filter
Filter
Make sure the
“FRONT” is
facing back
side.
CAUTION
Do not bend the air cleansing
and deodorizing filter as it may
cause damage to the structure.
Cleaning and maintenance must be carried out only by qualified service personal. Before cleaning,
stop operation and switch off the power supply.
CAUTION
!
To Next Page
Loading...
