Hitachi RAS-(3-6)HVNC1(E) - Page 203

6 Optional functions
189
SMGB0087 rev.0 - 12/2013
6
Element Optionalfunction
Individual
setting
Settings Settingconditions Description
J9
Not available – –
Not available (Use
as 00 conditions)
PC-ARF only
JA
Not available – –
Not available (Use
as 00 conditions)
PC-ARF only
Jb
Not available – –
Not available (Use
as 00 conditions)
PC-ARF only
K1
Not available X –
Not available (Use
as 00 conditions)
PC-ARF only
K2
Not available X –
Not available (Use
as 00 conditions)
PC-ARF only
K3
Not available X –
Not available (Use
as 00 conditions)
PC-ARF only
K4
Not available – –
Not available (Use
as 00 conditions)
PC-ARF only
K5
Human sensor
detection level
–
00 Standard PC-ARF only
01 High PC-ARF only
02 Low PC-ARF only
O: allows for individual setting.
X: the setting is made for all outdoor units.
–: not used.
*1 Setting “02” is not available on all indoor units.
*2 On RPI units: 00 Increases speed 1 (standard), 01 Increases speed 2 (high static pressure), 02 Standard speed (low
static pressure).
*3 00 standard (7-step operation); 01 draft prevention (cannot be set below two steps); 02 High ceilings (cannot be set
above two steps).
*4 In case that the set temperature is changed and kept within the set time at “F4”, the temperature is automatically
changed to “F5” and “F6”. In case that the set temperature is out of range at “F5” and “F6”, it is applied within upper and
lower limit for the set temperature.
*
5 Operation is stopped by pressing the run/stop switch for 3 seconds.
*
6 When the unit is restared by the remote control switch, the temperature automatically changes to the setting temperature
of “F5” or “F6”.
*7Thesensorvalueat“C8”willbeindicated.Whenthethermistorforremotecontrolswitchisused,theaveragevalueof
thethermistorforremotecontrolswitchandthethermistorforindoorinletwillbeindicated.
*8:Applicabletofan,coolinganddryoperationmodes.
*9:Applicabletoheatingoperationmode.
 N O T E
• Makesthechangestotheoptionalsettingsatleastthreeminutesfollowingstart-up.
• Onmodifyingthe”CF”(airoutletlouveranglechange)setting,restorethepowersupplyorallowtheautomaticlouver
tomakeafullcycleinautomaticmodetoapplytheoptionalsetting.
• Theoptionalfunctionsettingsaredifferentdependingontheindoororoutdoorunits.Checkthattheunithastheop-
tionalsetting.
• Theaboveoptionalfunctionswith“X”markattheindividualsettingcanchangetheconditiononlywhen“AllRooms”
isset.