10 Servicing
404
SMGB0087 rev.0 - 12/2013
1
2
3
4
5
6
7
Vibration-proof
Rubber 2
Vibration-proof
Rubber 1
Nut
Compressor
position
Cover pipes
with wet cloth
Suction pipe
Discharge
pipe
Fixation of the compressor to the bottom plate
Compressor position 1 2 3 4
Vibration-proof rubber 1 x x x x
Vibration-proof rubber 2 x x — —
Nut x x — —
9 Reassemble the parts in the reverse order of removing
procedures.
a. Tighten the screws (U V and W) for compressor wi-
res with 2.5 Nm.
b. Fix the wires rmly.
c. Attach the crankcase heater without torsion and
gap to the compressor as following gure.
Detail of Spring for Crankcase Heater
Crankcase Heater
Compressor
When attaching the spring, pay
attention not to damage the
crankcase heater.
To Next Page
Loading...
