EasyManua.ls Logo

Hitachi RAS-(4-12)HNP(1)(E) - Ras-(4-6)H(V)Nc1 E

Hitachi RAS-(4-12)HNP(1)(E)
498 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5 Control System
141
SMGB0087 rev.0 - 12/2013
5
Connectorindication
PCN1 Power supply connector (1~only)
R1,N1,R2,
S2,T2
Power supply and reverse phase detection (3N~
only)
PCN5 Crankcase heater of compressor (oil)
PCN6 4-way solenoid valve
PCN7 Solenoid valve
PCN8 High pressure switch protection
PCN9 Compressor contactor
PCN13 Low pressure switch protection
PCN406 Power connection between PCB and DIP-IPM
THM7 Outdoor air temperature thermistor
THM8 Pipe evaporation temperature thermistor
THM9 Compressor discharge temperature thermistor
THM10 Compressor suction temperature thermistor
CN1 Input function
CN2 Demand input
CN5A Micro electronic expansion valve
CN6 Transmission between PCB and DIP-IPM
CN7 External output
CN8 Transmission from outdoor to indoor unit
5.2.4  RAS-(4-6)H(V)NC1E
Connectorindication
CN404 Line connection between PCB and DIP-IPM
CN406 Motor for fan
EF1,2,3
EFR1
Power protection
Switchindication
DSW1 Test run
DSW2 Auxiliary function setting
DSW3 Capacity code
DSW4/
RSW1
Refrigerant cycle number
DSW5 End terminal resistance
DSW6 Simultaneous / individual operation
LEDindication
LED1 Red Power source for the PCB
LED2 Green
This LED indicates the transmission status
between the indoor unit and the RCS
LED3 Yellow
This LED indicates the transmission status
between the indoor unit and the outdoor unit
LED4 Red Power source at 280V for the PCB

Table of Contents

Related product manuals