Hitachi RAS-(4-12)HNP(1)(E) - Temperature Indication

8 Troubleshooting
278
SMGB0087 rev.0 - 12/2013
Although the wireless controller is used for the wall type indoor unit with the built-in receiver part, you can check the alarm
code by connecting the PC-P2HTE.
Suction grille
Connector
for check
N O T E
• The unit does not operate by pressing the operation switch.
• The above function is available only when the alarm occurs.
• The PCB check using the remote control switch is not available.
• The indication is the data when you are connecting PC-P2HTE. The indication is not the data before the alarm occurs.

Contents of the check mode 1
The next indication is shown if you press the part “
” of the TEMP switch. If you press the part “” of the TEMP switch,
the previous indication is shown.
Temperature indication
Indication of the category code
Indication of the temperature, etc
1
Indoor unit temperature setting
(°C)
b1 22
2
Indoor unit air inlet temperature at
thermistor (°C)
b2 20
Normal ... Temperature displayed
3
Indoor unit discharge air
temperature at thermistor (°C)
b3 55
Abnormal
--
(Thermistor is open-
circuited or PCB is defec-
tive)
or
4
Indoor unit heat exchanger liquid
pipe temperature (°C)
b4 20 12g
(Temperature for top of
compressor)
5 Temperature at remote sensor (°C)
b5 25

(Thermistor is short-
circuited or PCB is defec-
tive)
or
6
Outdoor unit ambient temperature
(°C)
b6 10
255
or
7
Indoor unit heat exchanger gas
pipe temperature (°C)
b7 25
127
(Temperature for top of
compressor)
8
Outdoor unit evaporating
temperature during heating (°C)
b8 02
Refer to section “Self-checking proce-
dure of PCB by means of the Remote
Control Switch”
9 Control information
bg --
During the transient periods such as starting time and other, the
indicators “--” or “00” may be displayed for a limited time.
This is indicated only when a remote sensor is connected.
The indicator “
--” is normally displayed.
RPK series cannot connect a remote sensor.
Therefore, the indicator is “--”.
This indicates the internal information for the remote control switch.
This does not have any specic meaning.
(Ex.) During the operaton of several compressors, the average
temperature of two compressors is indicated.
If the temperature is higher than 126 ºC, “
126”
10
Discharge gas temperature at the
top of the compressor chamber
(°C)
bA 41
11
Thermo temperature of the
remote control switch
bb 23