Hitachi RAS-(4-12)HNP(1)(E) - Removing Other Electrical Components

10 Servicing
360
SMGB0087 rev.0 - 12/2013
10.2.8.2 Removing other electrical components
1 Remove the pipe cover following Removingpipecover.
2 Remove 3 xing screws and remove the upper cover.
3 Remove the electrical box cover.
4 Removing Electrical Components.
Remove the xing screw and remove the reactor.
• To mount components be sure to match the wiring connection with the mark band codes.
1 Electrical box cover.
2
Partition plate.
3
Fuse.
4
Electrical box.
5
Reactor.
6
See the note.
1
2
3
4
5
6
N O T E
ThePCBcannotberemovedfromtheelectricalbox.ToreplacePCBtheentireelectricalboxmustbereplaced.