Hitachi RAS-(4-12)HNP(1)(E) - Removing Upper Cover; Removing Bottom Service Cover and Rear Cover

10 Servicing
362
SMGB0087 rev.0 - 12/2013
10.3.3 Removing upper cover
Remove the upper cover upward after removing 9 xing screws.
1
1 Upper cover
10.3.4 Removing bottom service cover and rear cover
1 Remove 5 screws which x the bottom service cover. Pull and re-
move the bottom service cover.
2 Remove the upper cover following “10.3.3Removinguppercover”.
3 Remove 9 screws which x the rear cover. Pull backward and re-
move the rear cover.
Rear Cover
Valve Stay
Electrical Box
Front Side
Piping Cover
Air Outlet Grille
Air Outlet Grille
Valve Stay
Front Side
Piping Cover
Rear Cover
Electrical Box
Rear Cover
Air Inlet Grille
Position of
Ambient
Thermistor
Air Inlet
Grille
Rear Cover
Position of
Ambient
Thermistor
N O T E
Payattentionthatthescrewlengthfortheambientthermistordiffersfromotherxingscrews.