Hitachi RAS-(4-12)HNP(1)(E) - Ras-(4-6)H(V)Np1 E

10 Servicing
372
SMGB0087 rev.0 - 12/2013
10.4 RAS-(4-6)H(V)NP1E
10.4.1 Removing service cover
N O T E
• Follow the procedure below to remove main parts and components. For mounting follow the reverse procedure of
removal.
• Donotexposetherefrigerantcycletotheatmosphereforalongperiodtoavoidmoistureordustenteringintothecycle.
Besuretoreplacepartsimmediatelyafterremoving.Sealtherefrigerantcyclewhenleftunattachedforalongperiod.
1 Remove the 4 xing screws, slide the service cover downward and
remove it.
• Pay attention not to fall off the service cover.
Service Cover
Service
cover
10.4.2 Removing air outlet grille
1 Remove the 8 xing screws of the shroud.
Air Outlet Grille
Air Outlet Grille
Shroud
Air outlet grille
Shroud
Air outlet grille