Hitachi RAS-(4-12)HNP(1)(E) - Page 413

10 Servicing
399
SMGB0087 rev.0 - 12/2013
10
10.6.3 Removing upper cover
1 Remove 11 screws xing the upper cover and remove the upper
cover upward.
Upper
cover
10.6.4 Removing the bottom service cover and rear cover
1 Remove 5 screws xing the lower part of service cover and remove
the lower part of service cover by pulling towards front side.
2 Remove the upper cover according to the item “10.6.3Removing
uppercover”.
3 Remove 10 screws xing panel and remove the rear panel by pu-
lling in the arrow direction.
1
2
2
3
4
5
6
Air outlet
grille
Rear
cover
Bottom
service cover
Position of ambient
thermistor
Rear cover
Air inlet
grille
Pull