Hitachi RAS-(4-12)HNP(1)(E) - Wind Guard; Attaching Example of Air Wind Guard; Two Windguard Covers Installation; Service Space

2 Unit Installation
34
SMGB0087 rev.0 - 12/2013

Wind guard
Specications
Model WSP-264
Quantity 1 per unit
1
2
1 4-6x10 Long Hole
2 5 (Both Sides) - M5 Screw (attachement)
Material Galvanized sheet metal + baked painting
Color UTOPIA Beige
Weight 4.0 kg
Accessories
Fixing screw x 4 [M5 (SUS) x 30]- Unit
Fixing Screw x 10 [M5 (SUS) x 12]- Wind Ward
Installation manual
Installation
restriction
“Guard net” “Air ow guide” or “Snow protection
hood” is not available to install with Wind guard
Attachingexampleofairwindguard
• Attach the air ow guide to the air discharge grille with four (4) screws (supplied).
• The xing holes are located at 4 positions on the grille. (Screw tightening torque 2.4 3.1 N.m)
• Do not remove the air discharge grille for air ow guide installation.
 C A U T I O N
Iftheairguideisinstalledwithoutdischargegrilleitmaycauseinjuryduetorotatingfan.
Twowindguardcoversinstallation
1.Air discharge grille
2.Outdoor unit
3.M5 xing screw x4 (Accessories)
1
1
2
3
Servicespace
• Both sides of the outdoor unit should be open.
• No obstacles should be placed in the air discharge side.
1
2
3
1.Min.150 mm
2.Outdoor unit
3.Wind guard