Hitachi RAS-(4-12)HNP(1)(E) - Attaching Example of Snow Protection Hood; Specifications of Snow Protection Hood

2 Unit Installation
36
SMGB0087 rev.0 - 12/2013
Attachingexampleofsnowprotectionhood
1
1
2
3
1 1
4
2 1
5
1
BA C
1. Fixing screw (accessories)
2. Air inlet hood
3. Wire rope (optional for over turning protection)
4. Air discharge hood
5. Outdoor unit
A. Rear side
B. Left side
C Front side
 N O T E
Theholeslocationsmarkedwithamarkshallbemadebyusingselscrew(M4X13)andlatershallbeusedSUSScrewfor
xingprotectionhood.
Specicationsofsnowprotectionhood
Productname Airdischargehood Rearsuctionhood Leftsuctionhood
Model ASG-NP80F ASG-NP80FS ASG-NP56B ASG-NP63BS2 ASG-NP56L ASG-NP63LS2
Quantity 1 per unit
Material
Bonderized
steel sheet
Iron
Stainless
(NSSC180)
Bonderized
steel sheet
Iron
Stainless
(NSSC180)
Bonderized
steel sheet
Iron
Stainless
(NSSC180)
Color
Gray
(1.0Y8.5/0.5 or
approximation)
—
Gray
(1.0Y8.5/0.5 or
approximation)
—
Gray
(1.0Y8.5/0.5 or
approximation)
—
Weight 3 kg 6 kg 3 kg
Assembling Knockingdown parts (assembled at eld)
Components
Hood For air discharge part x 1 For rear side air intake x 1 For left side air intake x 1
Unit
Fixing screw
4 (M5x12 tapping screw) 5 (M5x12 tapping screw) 4 (M5x12 tapping screw)
Hood
Fixing screw
(SUS)
6 (M5x12
tapping screw)
6 (M5x14)
14 (M5x12
tapping screw)
14 (M5x14)
10 (M5x12
tapping screw)
10 (M5x14)
Self-screw 2 (M4x13) 2 (M4x13) 2 (M4x13)
Installation manual
Installation restriction
Installation with “Guard net”
“Wind guard” or is not
available
Installation with “Guard net” is not available
Safety wire rope for overturning
prevention (optional parts)
ASG-SW20A