Hitachi RAS-(4-12)HNP(1)(E) - Optional Parts and Installation RAS-(4-6)H(V)NC1 E

2 Unit Installation
42
SMGB0087 rev.0 - 12/2013
2.7.3 Optional parts and installation RAS-(4-6)H(V)NC1E

Air ow guide wind guard and snow protection hood
Optionalparts Model
Air ow guide AG-335A
1
3
2
1 Air ow guide
2 Wind Guard
3 Snow protection hood
Wind guard WSP-335A
Snow protection
hood
Zinc plate
Air outlet ASG-NP335F
Air inlet of rear side ASG-NP80B
Air inlet of side face ASG-NP80L
Stainless plate
(SUS304)
Air outlet ASG-NP335F52
Air inlet of rear side ASG-NP160BS2
Air inlet of side face ASG-NP160LS2

Air ow guide
Specications
Model AG-335A
Quantity 1 per unit
1
1
2
1 Mounting dimension
2 Air ow guide
Air discharge
direction
Upward (downward) left & right
Material Weather proof polypropylene resin
Color Gray
Weight 1.9 kg
Accessories
Fixing screw x 4 [M5 (SUS) x 20]
Installation manual
Installation
restriction
“Wind Guard” or “Snow protection hood” is
not available to install with air ow guide.
(“Guard net” is available to be installed
together.)
Attachingexampleofairowguide
• Attach the air ow guide to the air discharge grille with four (4) screws (supplied).
• The xing holes are located at 4 positions on the grille. (Screw tightening torque 2.4 3.1 N.m)
• Do not remove the air discharge grille for air ow guide installation.
 C A U T I O N
Iftheairguideisinstalledwithoutdischargegrilleitmaycauseinjuryduetorotatingfan.