Hitachi RAS-(4-12)HNP(1)(E) - Optional Parts and Installation RAS-(4-6)H(V)NPE; RAS-(8-10)HN(P;C)E

2 Unit Installation
49
SMGB0087 rev.0 - 12/2013
2
2.7.4 Optional parts and installation RAS-(4-6)H(V)NPE / RAS-(8-10)HN(P/C)E

Air ow guide wind guard and snow protection hood
Optionalparts Model
Air ow guide AG-335A X 2
1 2
3
1 Air ow guide
2 Wind Guard
3 Snow protection hood
Wind guard WSP-335A X 2
Snow
protection
hood
Zinc plate
Air outlet ASG-NP335F X 2
Air inlet of rear side ASG-NP280B
Air inlet of side face ASG-NP280L
Stainless plate
(NSSC 180)
Air outlet ASG-NP335FS 2X 2
Air inlet of rear side ASG-280BS2
Air inlet of side face ASG-NP280LS2

Air ow guide
Specications
Model AG-335A Image
Quantity 2 per unit
1
1
2
1 Mounting dimension
2 Air ow guide
Air discharge
direction
Upward (downward)
left & right
Material
Weather proof
polypropylene resin
Color Gray
Weight 1.9 kg
Accessories
Fixing screw x 4
[M5 (SUS) x 20]
Installation manual
Installation
restriction
“Wind Guard” or “Snow protection hood” is not
available to install with air ow guide. (“Guard
net” is available to be installed together.)
Attachingexampleofairowguide
• Attach the air ow guide to the air discharge grille with four (4) screws (supplied).
• The xing holes are located at 4 positions on the grille. (Screw tightening torque 2.4 3.1 N.m)
• Do not remove the air discharge grille for air ow guide installation.
 C A U T I O N
Iftheairguideisinstalledwithoutdischargegrilleitmaycauseinjuryduetorotatingfan.