Hitachi RAS-(4-12)HNP(1)(E) - Optional Parts and Installation RAS-12 HN(P;C)

2 Unit Installation
55
SMGB0087 rev.0 - 12/2013
2
2.7.5 Optional parts and installation RAS-12HN(P/C)

Air ow guide wind guard and snow protection hood
Optionalparts Model
Air ow guide AG-335A X 2
1 2
3
1 Air ow guide
2 Wind Guard
3 Snow protection hood
Wind guard WSP-335A X 2
Snow protection
hood
Zinc plate
Air outlet ASG-NP335F X 2
Air inlet of rear side ASG-NP335B
Air inlet of side face ASG-NP335L
Strainless
plate(NSSC 180)
Air outlet ASG-NP335FS2 X 2
Air inlet of rear side ASG-335BS2
Air inlet of side face ASG-NP335LS2

Air ow guide
Specications
Model AG-335A
Quantity 2 per unit
1
1
2
1 Mounting dimension
2 Air ow guide
Air discharge
direction
Upward (downward) left & right
Material Weather proof polypropylene resin
Color Gray
Weight 1.9 kg
Accessories
Fixing screw x 4 [M5 (SUS) x 20]
Installation manual
Installation
restriction
“Wind Guard” or “Snow protection hood” is not
available to install with air ow guide.
(“Guard net” is available to be installed toge-
ther.)
Attachingexampleofairowguide
• Attach the air ow guide to the air discharge grille with four (4) screws (supplied).
• The xing holes are located at 4 positions on the grille. (Screw tightening torque 2.4 3.1 N.m)
• Do not remove the air discharge grille for air ow guide installation.
 C A U T I O N
Iftheairguideisinstalledwithoutdischargegrilleitmaycauseinjuryduetorotatingfan.