10 Servicing
392
SMGB0064 rev.0 - 08/2011
Fixation of the compressor to the bottom plate
Compressor position 1 2 3 4
Vibration-proof rubber 1 x x x x
Vibration-proof rubber 2 x x — —
Nut x x — —
Removing high pressure switch and control pressure switch
1 Remove the service cover according to the section Removing
service cover, see on page 385 in this chapter
2 Collect the refrigerant from the check joint according to the sec-
tion Removing the compressor, see on page 389 in this chapter.
3 Disconnect the fasten terminals from the pressure switches.
• Cut the high pressure switch (63H1) and control pressure
switch (63H2) from the brazing neck using a burner.
1. Upper cover box.
2. Rear cover.
3. Electrical box.
4. Brazing part.
5. Pressure switch for control (PSC).
6. Discharge pipe.
7. High pressure switch (PSH).
1
2
3
4
4
5
6
7
To Next Page
Loading...