Hitachi RAS-(4-6)HVRNS2E - Attaching Example of Snow Protection Hood; Specifications of Snow Protection Hood

2 Unit Installation
32
SMGB0064 rev.0 - 08/2011
Attaching example of snow protection hood
1
1
2
3
1 1
4
2 1
5
1
BA C
1. Fixing screw (accessories)
2. Air inlet hood
3. Wire rope (optional for over turning protection)
4. Air discharge hood
5. Outdoor unit
A. Rear side
B. Left side
C Front side
N O T E
• The holes locations marked with a mark shall be made by using sel screw (M4X13) and later shall be used SUS
Screw for xing protection hood.
Specications of snow protection hood
Product name Air discharge hood Rear suction hood Left suction hood
Model ASG-NP80F ASG-NP80FS ASG-NP56B ASG-NP63BS2 ASG-NP56L ASG-NP63LS2
Quantity 1 per unit
Material
Bonderized steel
sheet
Iron
Stainless
(NSSC180)
Bonderized steel
sheet
Iron
Stainless
(NSSC180)
Bonderized steel
sheet
Iron
Stainless
(NSSC180)
Color
Gray (1.0Y8.5/0.5
or approximation)
—
Gray (1.0Y8.5/0.5
or approximation)
—
Gray (1.0Y8.5/0.5
or approximation)
—
Weight 3 kg 6 kg 3 kg
Assembling Knockingdown parts (assembled at eld)
Components Hood For air discharge part x 1 For rear side air intake x 1 For left side air intake x 1
Unit
Fixing screw
4 (M5x12 tapping screw) 5 (M5x12 tapping screw) 4 (M5x12 tapping screw)
Hood
Fixing screw
(SUS)
6 (M5x12 tapping
screw)
6 (M5x14)
14 (M5x12 tapping
screw)
14 (M5x14)
10 (M5x12 tapping
screw)
10 (M5x14)
Self-screw 2 (M4x13) 2 (M4x13) 2 (M4x13)
Installation manual
Installation restriction
Installation with “Guard net” “Wind
guard” or is not available
Installation with “Guard net” is not available
Safety wire rope for overturning preven-
tion (optional parts)
ASG-SW20A