Hitachi RAS-4-HNPE - General Notes Before Piping Work

2. Unit Installation
38
SMGB0079 rev.0 - 01/2013
Attaching example of snow protection hood
1
1
1
1
1
2
3
4
A
B
C
5
6
7
1. Fixing screw (Accessories).
2. Rear suction hood
3. Wire rope (Optional. For overturning protection)
4. Air discharge grille
5. Left suction hood
6. Air discharge hood
A. Left side
B. Front side
C. Rear side
Specications of snow protection hood
Product name Air discharge hood Rear suction hood Left suction hood
Model ASG-NP335F ASG-NP335FS2 ASG-NP80B ASG-NP160BS2 ASG-NP80L ASG-NP160LS2
Quantity 2 per unit 1 per unit
Material
Bonderized steel
sheet
Iron
Stainless
(NSSC 180)
Bonderized steel
sheet
Iron
Stainless (NSSC
180)
Bonderized steel
sheet
Iron
Stainless (NSSC
180)
Color
Gray (1.0Y8.5/0.5
or approximation)
—
Gray (1.0Y8.5/0.5
or approximation)
—
Gray (1.0Y8.5/0.5
or approximation)
—
Weight 3 kg 14 kg 8 kg
Assembling Knockingdown parts (assembled at eld)
Components Hood For air discharge part x 1
For rear side air intake x 1
(Upper side x 1 lowe side x 1)
For left side air intake x 1
Unit Fixing
screw
4 (M5x12 tapping screw) 5 (M5x14 tapping screw) 6 (M5x12 tapping screw)
Unit Fixing
screw (SUS)
6 (M5x12 tapping
screw)
6 (M5x14)
12 (M5x12 tapping
screw)
12 (M5x14)
10 (M5x12 tapping
screw)
10 (M5x14)
Installation manual
Installation restriction
Installation with “Guard net” or “Wind
guard” is not available
Installation with “Guard net” is not available
Safety wire rope for overturning
prevention (optional parts)
ASG-SW20A