Hitachi RAS-6HVRNS1E - Installation of Remote Controller; Test Running Procedures

Locations of fixing holes
The holes Location shall be made by using self-screws (M4x13)
and later shall be used SUS screw (M5x12) for fixing air flow guide.
1 Outdoor Unit
2 Hole (4 locations)
One flow guide installation
1 Air discharge grille
2 Air flow
3 Outdoor unit
4 M5 fixing screw x4 (Accessories)
5 Air flow guide
Service space (In case of upward air discharge)
• In case of right and left sides air discharge, enough space for
air discharge is required.
• The downward air discharge is also available. In such case,
install the base under the unit to secure enough space for air
discharge.
• In case of serial units installation, air discharge should be
upward.
1 Min.150 mm
2 Outdoor unit
3 Air flow guide
4 Passage side
1
2
1
2
3
4
4
5
1
2
3
4
2 Unit Installation
29
SMGB0060 rev. 1- 12/2010
2