Hitachi RAS-8FSXN - Removing the Electrical Box Cover

10.3 Removing the electrical box cover
D A N G E R
• Turn OFF all the power source switches.
N O T E
• For servicing use the following tool:
- Phillips screw driver.
10.3.1
Removing the electrical box cover for RAS-(8-12)FSXN
1 Remove the front service cover as described in the procedure
Removing the front service cover
, see on page 292.
2 Remove the two screws of the electrical box cover -B- and
loosen the two fixing screws, for fall prevention -C-.
3 Lift the electrical box cover -A- and remove it forward from the
screws -C-.
N O T E
• Before removing
the screws that fix the electrical box
cover, make sure that the screws -C- are fixed to the cover,
so that the cover will not fall.
• Take care not get injured with the edges of the front cover
when removing the electrical box cover.
10.3.2 Removing the electrical box cover for RAS-(14-18)FSXN
1 Remove the front service cover as described in the procedure
Removing the front service cover, see on page 292.
2 Remove the two screws of the electrical box cover -B- and
loosen the two fixing screws, for fall prevention -E-.
3 Lift the electrical box cover -A- and remove it forward from the
screws -D-.
4 Remove the two screws of the sub electrical box cover -B- and
loosen the two fixing screws, for fall prevention -F-.
5 Lift the sub electrical box cover -C- and remove it forward from
the screws -E-.
N O T E
• Before removing the screws that fix the electrical box
cover and the sub electrical box cover, make sure that the
screws -E and F- are fixed to the cover, so that the cover
will not fall.
• Take care not to get injured with the edges of the front
cover when removing the electrical box cover.
A
B
C
A
B
C
D
F
E
10 Servicing
294
SMGB0065 rev. 1 - 12/2010