5 Untie the laces -B- to remove the RC cover.
RC Cover
Compressor
Direction to Remove the Cover
N O T E
• Remove the RC cover in the direction indicated by the arrow.
• When
you
remove the RC cover take care not to deform the piping around the cover. The welding could be
damaged by the deformation of the pipe.
• When removing the compressor take care not to be injured with the edge of the metal sheet or the fins of the
heat exchanger.
• The aluminium sheet is a conductor. If the aluminium sheet is damaged it may cause a failure due to an electric
contact with the wiring. To avoid this failure, check the conditions of the RC cover when fixing.
10 Servicing
301
SMGB0065 rev. 1 - 12/2010
10
To Next Page
Loading...
