Hitachi RCIM-0.6FSN4 - Page 38

16.3 POSITION OF ELECTRICAL WIRING CONNECTION
 C A U T I O N
• (QVXUH WKDW WKH ZLULQJ WHUPLQDOV DUH WLJKWHQHG VHFXUHO\ ZLWK WKH
VSHFL¿HGWRUTXHV/RRVHWHUPLQDOVPD\FDXVHKHDWJHQHUDWLRQDWWKH
WHUPLQDOFRQQHFWLRQSDUWD¿UHRUDQHOHFWULFVKRFN
• )L[WKHFDEOHVVHFXUHO\([WHUQDOIRUFHVIURPWKHFDEOHVDSSOLHGRQ
WKHWHUPLQDOVFRXOGOHDGWRKHDWJHQHUDWLRQDQGD¿UH
• 0DNHVXUHWKDWWKHZLUHVDUHVHFXUHO\¿[HGLQRUGHUQRWWRDSSO\DQ
H[WHUQDOIRUFHWRWKHWHUPLQDOFRQQHFWLRQVRIWKHZLULQJV,I¿[LQJLVQRW
FRPSOHWHGKHDWJHQHUDWLRQRUD¿UHZLOORFFXU
The electrical wiring connection for the indoor unit is shown in
the item
'HWDLOVRIHOHFWULFDOZLULQJFRQQHFWLRQ. Refer
to
(OHFWULFDO:LULQJ chapter for details of the intermediate
connection between the indoor unit and the air panel.
The connections at the terminal board for the indoor unit
DUHVKRZQLQWKH¿JXUHEHORZ&KHFNWKHRXWGRRUXQLWWREH
combined before wiring work. The tightening torque for terminals
is shown in the table below.
Tightening Torque for terminals:
Screw Size Tightening Torque
TB1 M4 1.0 - 1.3 (N-m)
TB2 M3.5 1.2 (N-m)
Terminal board for power source
cable TB1 (black)
Terminal board for control cable
TB2 (white)
-
S/NR/L1
A B
1 2
 N O T E
:KHQXVLQJ WKH VWUDQGHG ZLUH IRU¿HOGZLULQJ FRQQHFWLRQ 0 FULPSLQJ
WHUPLQDOLVUHTXLUHG:KHQXVLQJWKHVLQJOHZLUHPDNHLWLQWRWKHVKDSH
VKRZQ LQ WKH ¿JXUH EHORZ EHIRUH FRQQHFWLQJ LW LQ RUGHU WR WLJKWHQ WKH
ZDVKHUXQLIRUPO\
Cr Te ow w.
Connect it with crimping
terminal
Stranded wire
Connect it direct as
shown below
Single wire
Connect the cable for the optional remote control switch or the
RSWLRQDOH[WHQVLRQFDEOHWRWKHWHUPLQDOVLQVLGHWKHHOHFWULFDOER[
through the connecting hole in the cabinet.
Connect the power supply and the earth wires to the terminals
LQWKHHOHFWULFDOER[
Connect the wires between the indoor unit and the outdoor unit
WRWKHWHUPLQDOVLQWKHHOHFWULFDOER[
Tie the wires together with the cord clamp inside the electrical
ER[
Perform wiring work for the indoor unit according to the electrical
wiring diagram and Installation and Operation Manual of the
outdoor unit.
 N O T E
• &RQQHFWWKHFDEOHVFRUUHFWO\DFFRUGLQJWRWKHPDUNVDQGQXPEHUVRQ
WHUPLQDOERDUG
• ,QVWDOO WKH WUDQVLWLRQ ZLULQJ EHWZHHQ LQGRRU XQLWV FRQQHFWHG WR WKH
VDPHRXWGRRUXQLW
• 'R QRW FRQQHFW WKH PDLQ SRZHU VRXUFH FDEOHV WR WKH FRQWURO OLQH
7HUPLQDOV$%DQGRI7%,ILWLVFRQQHFWHGWKHSULQWHGFLUFXLW
ERDUG3&%ZLOOEHEURNHQ
• Comply with the following points when connecting wires to the
WHUPLQDOERDUG
 $$WWDFKDQLQVXODWLRQWDSHRUDVOHHYHWRHDFKWHUPLQDO
 %0DNHVXUHWKDWWKHWHUPLQDOVDUHQRWWRRFORVHWRWKHHOHFWULFDO
ER[WRSUHYHQWDVKRUWFLUFXLW
 &0DNHVXUHWKDWWKHWHUPLQDOVDUHQRWWRRFORVHWRHDFKRWKHU
$WWDFKDQLQVXODWLRQWDSHRUDVOHHYHWRHDFKWHUPLQDO
(A)
(B)
(C)
Screw
Electrical wiring
PMML0363A rev.2 - 08/2016 - P541655928