11 BEFORE INSTALLATION
11.1 COMBINATION OF OUTDOOR UNIT AND INDOOR UNIT
The combination capacity of indoor unit against the outdoor unit is selected by the outdoor unit capacity. Refer to the installation
manual of outdoor unit and select the indoor unit and the outdoor unit to be satised the combination unit number and the
combination unit capacity.
11.2 TRANSPORTATION AND HANDLING
! CAUTION
Do not put any material on the product. Do not step on the product.
Transport the product as close to the installation location as
practical before unpacking.
Air inlet grille
Side cover
Louver
Lower cover
Side cover
Do not handle the side cover.
Side cover
Do not put any material on the indoor unit.
Remove the side cover when the indoor unit is moved after
unpacking. If not, the side cover may be damaged so that may
cause injury.
Removing side cover
1 Open the air inlet grille.
2 Remove the xing screw (M4).
Fixing screw
(M4)
3 Push the side cover forward to remove the hooks and the
hooking plate.
Position of xing screw
Hooking plate
Hooks
(3 portions)
4 Remove the side cover to lift upward.
When the indoor unit is unpacked, moved and installed, do not
take the air inlet grille, louver and lower cover. Additionally, do
not apply an excessive force to them. The air inlet grille, louver
and lower cover are deformed or damaged.
! DANGER
Do not put any foreign material into the indoor unit and check to
ensure that no foreign material exists in the indoor unit before the
installation and the test run. Otherwise, a re or failure, etc. may
occur.
! CAUTION
• The indoor unit covers are resin made. Do not apply an excessive
force to the resin covers or make it fall.
• Do not move the louver by hand. If moved, the louver mechanism will
be damaged.
? NOTE
To avoid damage to the resin covers, before lifting or moving the indoor
unit, put a cloth on the resin covers.
BEFORE INSTALLATION
PMML0551 rev.4 - 07/2023 - A10762310A
12
To Next Page
Loading...
