Hitachi RPI-1.0FSG1 - Removing Indoor Fan and Fan Motor

2-52
SERVICING
(2.3 In-the-Ceiling Type)
2.3.3 Removing Indoor Fan and Fan Motor
(1) Remove the electrical box cover according to the item 2.3.2 “Removing Printed Circuit Board (PCB)”.
(2) Remove four (4) screws fixing the electrical box plate and remove the electrical box plate.
(3) Disconnect the connector for the fan motor.
(4) Remove three (3) screws fixing the electrical box and
remove the electrical box on the unit as shown.
Phillips ScrewdriverTool
TURN OFF all power source switches.
(5) Remove three (3) screws fixing the ring and remove the ring.
(6) Loosen the screw fixing the fan runner onto the fan motor shaft and remove the near side fan runner.
(7) Remove the screw fixing the fan casing and
pull out the near side fan casing.
Phillips Screwdriver,
Hexagonal Wrench (M8)
Tool
Electrical Box Cover Electrical Box Plate
Fan Casing
Fixing Screws
Ring Fixing Screws
Runner Fixing Screw
Electrical Box