Hitachi RPI-1.0FSG1 - Removing Electronic Expansion Valve and Thermistors

2-54
SERVICING
(2.3 In-the-Ceiling Type)
2.3.4 Removing Electronic Expansion Valve and Thermistors
(1) Remove three (3) screws fixing the heat exchanger cover and remove the heat exchanger cover.
(2) Remove four (4) screws fixing the maintenance
cover and remove the maintenance cover.
Phillips ScrewdriverTool
TURN OFF all power source switches.
(3) Remove the electronic expansion valve by using two (2) spanners.
(4) Remove the thermistors attaching the pipe of
heat exchanger.
Phillips Screwdriver, SpannerTool
Maintenance Cover
Screws
Heat Exchanger Cover Screws
ThermistorExpansion Valve