2-68
SERVICING
(2.5 2-Way Cassette Type)
2.5.4 Removing Fan Runner and Fan Motor
(1) Remove the optional air panel according to the item 2.5.3 “Removing Optional Air Panel”.
(2) Removing Electrical Box
(a) Disconnect the connectors for each wire.
(b) Remove two (2) screws fixing the electrical box and turn the electrical box downwards by
approximately 90. (The electrical box is hung by the hinge. Do not remove the fixing screws for
the hinge.)
TURN OFF all power source switches.
Phillips ScrewdriverTool
(3) Removing Bell-Mouth
Remove the fixing plate after removing one (1) screw fixing the fixing plate on the support plate of the
indoor unit. (For 4.0 and 5.0HP)
Remove the bell-mouth by removing two (2) screws fixing the bell-mouth onto the fixing plate for the
drain pan of the indoor unit.
* Q’ty of Bell-Mouth: 1 (RCD-1.0 to 3.0FSG1)
2 (RCD-4.0 to 5.0FSG1)
Phillips ScrewdriverTool
RCD-4.0FSG1 and RCD-5.0FSG1 RCD-1.0FSG1 to RCD-3.0FSG1
Fixing Plate for Drain Pan
Bell-Mouth
Bell-Mouth
Fixing Screw
Bell-Mouth
Bell-Mouth
Fixing Screw
Fixing Plate for Drain Pan
Bell-Mouth
Supporting Plate
Fixing Plate
Hinge
Screw
Hinge
Screws
Electrical
Box
To Next Page
Loading...
